Almost all of stores are equipped with one or more beverage refrigerated merchandisers. Then now we are to explain the reasons why there is an increase in power consumption for the beverage refrigerated unit, There are some factors are reflected in the following points. You can follow the instructions in this article to reduce the power consumption of the beverage refrigerated merchandisers.

Many reasons for the increasing in power consumption of the beverage merchandisers, except for the reason that the beverage merchandiser itself for its large size and high temperature requirement with a lager power ,other reasons for high power consumption are generally reflected in the usage and maintenance for the merchandiser. The reasons for the power consumption of the beverage merchandisers are shown as the following points.

Convenience store six sections refrigerated merchandiser

1 The temperature surround the merchandiser

The indoor temperature will affect the cooling effect of a beverage merchandiser in a curtain degree. The places with a bigger temperature change will increase the failure rate of accessories in the unit, and it will affect the display effect with much fog containing on the glass door. We should try to keep the stability of the ambient temperature surround the beverage merchandiser to reduce the load of the compressor. Ambient temperature has a direct impact on the power consumption of the refrigerator. The higher temperature is, the lower cooling speed it will be. Take the experimental data analysis of an ordinary freezer as an example: the power consumption in a ambient temperature of 32 ℃ is about twice at 25 ℃.The power consumption with 30 ℃ is 1.6 to 1.8 times when comparing with 25 ℃. Therefore, the refrigerated unit should be placed away from the heat source as far as possible and it will better with wind circulation. 

2 , set a reasonable temperature

Each freezer has a temperature control by adjusting gear to adjust the refrigerator temperature, the higher the thermostat stalls, the lower the temperature inside the freezer. After the freezer reaches -18 ℃, 1 ℃ each drop is difficult, the more difficult it cool down, but less continuous operation minimum temperature can reach -24 ℃, but this time will be the same because of the temperature difference between inside and outside, cooling capacity lost more the emergence of a very long boot time or even stop. This thermostat only for domestic refrigerators, but as a commercial freezer manufacturers, the leading brand of convenience store freezer used Andre freezer thermostat, are precise microcomputer control cabinet display cabinet moderate temperature, the error is smaller, cabinet the temperature at a glance; convenience store freezer series is set at the factory to shut down 3 degrees, 8 degrees boot, but it is certainly in the middle of the temperature difference, the weather when the temperature sometimes rises to 11-12 degrees, this phenomenon is It is normal.

 
 Third, avoid repeated opening stop drinks cabinet
 
      Repeatedly stop constantly open drinks cabinet will affect the life of repeatedly starting or stopping the process will increase the workload of the compressor, greatly increases the power consumption. In use in the drinks cabinet drinks cabinet not exactly need to be closed, try not to close the convenience store drinks cabinet, in order to ensure energy saving temperature can also follow the manufacturer's instructions.

Fourth, to minimize the number of door.

Open drinks cabinet door can feel the cold air ran out, and the air conditioning to run away would inevitably result in a temperature rise in the freezer, it will cause a delay in the thermostat temperatures reach down and cause the compressor to work long hours, power consumption increases Big.