Note the following points when a site survey:

1 to determine the actual size of a good cold storage, be sure to use a tape measure accurately, about the size and height to the nearest CM. It is installed in the room or outdoors, the size and direction of the door is open the eyes of customers and classification freezer door door. There are cold plate thickness, and whether to reserve the drainage holes in the room? We must pay attention to these details.

2 voltage customers cold storage units use a 220V or 380V? Conventional compressor 1P-4P as a two-phase 220V, 5P above is 380V three-phase power, power lines are usually equipped with cold storage next to the refrigerator door 1-2 meters. The power line is configured to cold, the compressor power consumption of 780W per hour 1P, 2P compressor power consumption was 1560W per hour, and so on. 1 square copper can withstand the maximum current of 6A, equivalent to about 1000W power appliances. 1 square aluminum can withstand 4A current, approximately equal to 750W of electrical power.

3 refrigerator parts delivery, less than 50 cubic meters of cold storage delivery time of 10-12 days, 50-100 cubic meters of cold storage delivery time of 12-15 days. 100 cubic -200 cubic 18 days.

4 conventionally refrigerated cold storage units are used Panasonic, freezing cold are used (except for non-standard) Copeland unit. Cold plate will be color steel, standard sliding door, cold plate thickness of 100mm.