List of common problems to check
Electric:
1.
Is
the plug correctly and tight inserted without wobbling?
2.
Is
the mother plug a quality one?
3.
Does
the mother plug has a real ground?
4.
Is
the wire free of 90 degrees curves and without anything on it?
5.
Is
the wire without scratches?
Necessary cleanness of the showcase:
1.
Assure
that the fans are working properly
2.
Check
and clean the radiator under the showcases
3.
Assure
that the evaporator is not full of ice
4.
Assure
that the showcase is not working 24 hours
5.
Assure
that is in an air-conditioned environment
6.
Are
all the pans correctly inserted?
Technical issue
The showcase is cold but not cold enough:
1.
Check
the compressor behavior (it should run and stop and run):
2.
Check
also the defrost timing and the defog switch
3.
If
the compressor is always running:
4.
If
the compressor does not run:
Maintenance of ice cream freezer
First check the electric connections; all the instruction are
the same as for the showcases:
1.
Is
the plug correctly and tight inserted without wobbling?
2.
Is
the mother plug a quality one?
3.
Does
the mother plug has a real ground?
4.
Is
the wire free of 90 degrees curves and without anything on it?
5.
Is
the wire without scratches?
6.
Did
you pay the last electric bill? -Belive me, we had this situation once!-
Necessary cleanness of the ice cream freezer:
1.
Leave
it to melt all ice cream from the ice cream freezer when you see the ice is
growing a lot all around the freezer basin; remove all the ice cream into
another freezer
2.
Assure
that the showcase is not working for 12 hours
3.
Clean
and dry with towels and then start again as normal
5.
Finally,
contact us! Into www.adl1688.com ,we have
shared a lot of excellent refrigeration products and freezer maintenance tips on our website
if it is OK probably there is a problem with fans or clean the evaporator and
check if there are all pans correctly inserted.
Clean the radiator under the showcase; if not enough probably need add gas,
need to contact technician
Check the setting of the controller (-15-18?), if are OK need to call
technician